Battery Tester

We're a member of the Li-Battery Manufacturing Equipment Standard Project which is organized by MIIT, a battery testing

system provider of the national key aerospace project, and a government-designated new energy project research and

development unit. Until now, over 800,000 channels of battery testing equipment have been run in the battery production line. The longest running time of the equipment has exceeded 10 years. service customers have covered the top 100 enterprises in

the battery industry.

RCDS-5V Charge and Discharge Testing System

1. High reliability, small size, low noise, intelligent back-end operation system; Support off-line, anti-reverse, data protection;
2. Support the second voltage systems comparison function;
3. Support multi-channel charge-discharge curve comparison;
4. Support software intelligent sorting and grouping function; Support multi-channels parallel function;
5. With high-quality discharge energy feedback to the grid, efficiency ≥ 75%;
6. Connector impedance monitoring to avoid unsafe problems due to poor contact or long-time oxidation of connectors.

RCDS-60V Charge and Discharge Test System

1. Support single-cell voltage consistency tests;
2. Support off-line,anti-reverse, data protection;
3. Support charge-discharge curve comparison;
4. Support channel parallel function;
5. With high-quality discharge energy feedback to the grid, efficiency≥85% ;
6. High power factor value, PF=0.99;
7. Modular design, support hot-plugging(could be added or removed devices at run time), and easy maintenance.

RCDS-100V~500V Charge and Discharge Test System

1. Support single cell voltage consistency testing;
2. Support off-line, anti-reverse, data protection;
3. Support RS485, CAN, and other battery pack communication；
4. The discharge energy feedback efficiency ≥90% to grid;
5. High power factor value, PF=0.99;
6. Small size, high energy density.

RCDS-500V/800V/1000V-100A/200A/300A/600A

1. Support single-cell voltage consistency testing;
2. With off-line, anti-reverse, data protection;
3. Support RS485, CAN, and other battery pack communication protocols;
4. The discharge energy feedback efficiency ≥92% to the grid;
5. High power factor value, PF=0.99;
6. Three-level balance technology, wide voltage output range for flexible circuit adaption to the harsh grid environment.

GGC 20V/10A

1. Support Customized testing, each testing function can do a combination; Support smart battery protection board EEPROM/FLASH Data read, write , comparison function;
2. Support analysis Gas Gauge information of pack, support bit comparison of registers, find out failure battery pack;
3. Support “DCR test ” and “ACR test ”, and test main Current loop load and impedance performance accurately;
4. Advanced bar code record and Shop Floor management interface, easy for production line management and after-sales service tracking;
5. Software supports multiple serial ports running simultaneously to improve production efficiency.

BMS Battery Management Testing System

1. With virtual battery design, not afraid of short circuits with a safer operation;
2. The virtual battery adopts a plug-in design, and can be freely expanded;
3. Support various test functions, test high accuracy, 1 uA for self-consumption current accuracy, voltage accuracy is 1mV;
4. The software supports the modular structure tests, and supports production verification and R&D data testing;
5. With strong compatibility to perfectly support various types of BMS protection board testing;
6. Support national standard charge signal simulation, CC, CC2, CP